|H/V LINE(S)|| This option allows you to create a stream composed of one or more horizontal| and / or vertical line segments. After selecting H/V Line(s), click on the body of|the module which the stream is exiting. The stream may then be completed in|one of two ways.|| (A) You can immediately click on the body of a second module. FD3 will then| attempt to connect the two modules in as efficient a way as possible.|| (B) You can click on an empty part of the flow diagram. If you do this, FD3 will|draw either a horizontal or vertical stream segment between the point on which|you just clicked and the point on which you previously clicked. You may continue|adding stream segments until you click on the body of another module to|complete the stream.|| In general, method (B) is only used when the streams automatically created by| FD3 using method (A) are unsatisfactory.|| DIAGONAL LINE|| This option allows you to connect two modules with a single line of arbitrary| slope. Click on the module which the stream exits and then click on the module|which the stream enters. FD3 will then make a stream which connects those two|points with a single straight line.|| BUMPS ON / BUMPS OFF|| Selecting Bumps On causes FD3 to make little bumps where ever streams| intersect. Selecting Bumps Off causes FD3 to stop making bumps and to erase| any existing bumps.|